Blowing / Filling / Capping block
Tech-Long BFC (Blowing/Filling/Capping block) is the combination of a PET Blow Molder a Filler and a Capper combined into one block of equipment.
The Tech-Long BFC range covers any type of container from 0,2L till 20L, with any Blower of our range, as well as any Filler type.
- Filler closed enclosure
The filler structure is fully covered and protected through filtered air Hepa Filtration System.
- Preform rinsing with Ultra Clean Air
As the preforms enter into the blowing section trough infeed starwheel, a spray of 2-3 bar of dry, ultra clean filtered air is blown into the preform, the air and particles are extracted out to a hood with a dust extraction unit.
- Fully protected transfer table
Bottles are transferred by starwheels holding the bottles under the neck: the transfer table is in a closed environment ensuring no bottle contamination, and is fully protected through filtered air Hepa Filtration System.
- Ultra clean execution
The filler table is of inclined base structure, including side wall collecting drains to evacuate residual water from the filler table.
Such combination leads to numerous advantages such as:
- Facilitate use of light weight preforms
- Reduced space usage
- Higher efficiency
- Eliminate the need of Air conveyor
- Eliminate the need for Bottle rinsing
- Reduced maintenance
- Only one operator required
![](https://www.tech-long.in/wp-content/uploads/2021/06/bfc2.jpg)
![](https://www.tech-long.in/wp-content/uploads/2021/06/bfc1.jpg)
![](https://www.tech-long.in/wp-content/uploads/2021/06/bfc3.jpg)